1 ipmb-l link sensor, 3 field replaceable unit (fru) information, Field replaceable unit (fru) information – Kontron RTM8242 User Manual
Page 22

9
www.kontron.com
X
Exceed critical threshold / Error Assertion
*
Power On/Off
-
Power On
N
No change
2.5.2.1
IPMB-L Link Sensor
The RTM8242 has an IPMB-L link to communicate with the processor board and other devices in the chassis
through IPMB-0 bus. MMC monitors the bus for any link failure and sends the bus failure event to the front
board upon the recovery occurs.
2.5.3
Field Replaceable Unit (FRU) Information
The FRU Information provides inventory data about the boards where the FRU Information Device is located.
The part number or version number can be read through software.
FRU information in the RTM8242 includes data describing the RTM8242 board according to AMC.0 R2.0
specification requirements. This information is retrieved from the RTM, enabling reporting of board-specific
information through a standardized mechanism.
8
FPGA VChange
FPGA Version Change Detection
*
N
9
Temp Air In
Inlet Temperature (degrees)
*
X
10
Temp Air Out
Outlet Temperature (degrees)
*
X
11
Temp Switch
Switch Temperature (degrees)
*
X
12
Temp MMC
Module Management Controller Temperature (Degrees)
*
X
13
Vcc +3.3VSUS
Voltage on board 3.3V suspend (management) power supply
*
X
14
Vcc +12V In
Voltage on board 12V payload power supply
-
X
15
Vcc +5V
Voltage on board 5V backend power supply
-
X
16
Vcc +3.3V
Voltage on board 3.3V backend power supply
-
X
17
Vcc +1.5V
Voltage on board 1.5V backend power supply
-
X
18
Vcc +1.2V
Voltage on board 1.2V backend power supply
-
X
19
Vcc +1V
Voltage on board 1.0V backend power supply
-
X
20
VPUMP
Voltage on board blue LED VPUMP suspend power supply
*
X
21
Power State
Board Power State
*
N
22
Power Good
Actual power good status
*
N
23
Health Error
General health status
*
N
IPMI
sensor
ID
Sensor Name
Description (Sensor Type, Event trigger)
Scanning En-
abled under
Power State
Health LED
(Green to Am-
ber)