3 sfp, 4 mmc boot block, 5 hardware management overview – Kontron RTM8242 User Manual
Page 20

7
www.kontron.com
Table 2-1:Approved SFP Copper list
Table 2-2:Approved SFP Optical list
2.3
SFP+
The RTM8242 has 8 SFP/SFP+ module connectors available on the RTM face plate. The SFP+ module signals
come from the front board at 1/10Gb through Zone 3 connectors after passing through a signal conditioning
PHY.
Table 2-3:Approved SFP+ list
2.4
MMC Boot Block
The MMC runs Boot Block and IPMI firmware from its internal 512KB flash memory.The Boot Block firmware
keeps the last two copies of the IPMI firmware in a dedicated external flash memory. The Boot Block
activates the selected IPMI image and can rollback a firmware update in case of problems.
2.5
Hardware Management Overview
The RTM MMC communicates with the front board using the IPMB-L channel. Kontron’s Intelligent RTM
address on the IPMB-L is fixed and has a value of 0xA6.
Manufacturer Part Number
Description
Company
ABCU-5710RZ
1000BASE-T Copper SFP Transceiver
Avago
FCLF-8521-3
1000BASE-T Copper SFP Transceiver
Finisar
Manufacturer Part Number
Description
Company
FTLF8519P2BNL
1.25 Gb/s 1000Base-SX Ethernet
Finisar
FTLX8571D3BCV
1G/10G Dual-Rate SFP+ transceivers
Finisar
Manufacturer Part Number
Description
Company
AFBR-703SDDZ
10Gb/1Gb Ethernet, 850nm SFP+ Transceiver
Avago
AFBR-703SDZ-IN2
10Gb Ethernet, 850nm SFP+ Transceiver
Intel
FTLX8571D3BCL
10Gb/s 850nm Multimode Datacom SFP+ Transceiver
Finisar
FTLX1471D3BCL
10Gb/s 1310nm Single Mode Datacom SFP+
Transceiver
Finisar