Kontron CP390 - Manual (Page 18)

CP390 Installation
ID 19976, Rev. 0200 Page 2 - 2 ® PEP Modular Computers GmbH
2. Installation
2.1 Board Installation
PMC Module Installation
1. Place the EMC gasket on the bezel of your PMC-Module
2. Unscrew the stand-off, which is positioned at the PCI-Bridge
3. Push the PMC bezel into the window of the front-panel of the CP390 and plug the
connectors together.
4. Use three screws (M2.5 x 6mm) to fix the board
Caution!
If you are using the non-hotswap version of the CP390, please
switch off the target system before installing the board in a free
slot. Failure to do so could endanger your life/health and may
damage your board or system.
ESD Equipment!
Your carrier board and PMC module contain electrostatically sen-
sitive devices. Please observe the necessary precautions to avoid
damage to your board:
• Discharge your clothing before touching the assembly. Tools
must be discharged before use.
• Do not touch components, connector-pins or traces.
• If working at an anti-static workbench with professional dis-
charging equipment, please do not omit to use it.
$ $ Note:
In order to support an active PMC carrier and, therefore, to
comply with the CPCI specification, it was necessary to
place the PCI-to-PCI bridge in the position where a socket
for mounting a stand-off would normally be (PMC specifica-
tion). As a result, the second stand-off has been omitted.