4 installation of external serial ata devices, 4 installation of external serial ata devices - 6, Installation cp-rio3-04s – Kontron CP-RIO3-04S User Manual
Page 38

Installation
CP-RIO3-04S
Page 3 - 6
ID 1036-1669, Rev. 1.0
3.4
Installation of External Serial ATA Devices
Up to two external SATA devices may be connected to the CP-RIO3-04S via the onboard SATA
connectors J5 and J6 as well as the appropriate SATA cables.
Some symptoms of incorrectly installed SATA devices are:
• Device on a SATA channel does not spin up: check power cables and cabling. May also
result from a bad power supply or SATA device.
The SATA connector on the CP-RIO3-04S provides only a data connection. The power
for this device must be supplied by a separate connector. For further information, refer
to the respective documentation of the device.
• SATA device fail message at boot-up: may be a bad cable or lack of power going to the
drive.
Warning!
The incorrect connection of power or data cables may damage the SATA
device and/or the CP-RIO3-04S.