Kontron CP381 - Manual (Page 4)

Preface CP381
Page iv © 2002 PEP Modular Computers GmbH ID 24107, Rev. 01
Chapter
2
2. Functional Description ................................................................................ 2 - 3
2.1 General Information ............................................................................... 2 - 3
2.1.1 Signal Conditioning ....................................................................... 2 - 3
2.1.2 DI ProComm Controller ................................................................. 2 - 3
2.1.3 System Interfaces ......................................................................... 2 - 4
2.1.4 Monitor and Control ....................................................................... 2 - 4
2.1.5 Software ........................................................................................ 2 - 4
2.2 Board Level Interfacing Diagram ........................................................... 2 - 5
2.3 System Interfaces .................................................................................. 2 - 6
2.3.1 Digital Input Interface .................................................................... 2 - 6
2.3.2 CompactPCI Interface and Pinout ................................................. 2 - 8
2.3.3 Test and Program Development ................................................... 2 - 9
2.3.3.1 JTAG/ISP Interface and Pinout ................................................. 2 - 9
2.4 CapROM EEPROM ............................................................................... 2 - 9
2.5 Monitor and Control (M/C) ................................................................... 2 - 10
2.5.1 Pre-Operation M/C ...................................................................... 2 - 10
2.5.2 Operation M/C ............................................................................ 2 - 10
Chapter
3
3. Installation ................................................................................................... 3 - 3
3.1 Hardware Installation ............................................................................. 3 - 3
3.1.1 Safety Requirements ..................................................................... 3 - 3
3.1.2 Installation Procedures .................................................................. 3 - 4
3.1.3 Removal Procedures ..................................................................... 3 - 5
3.2 Software Installation .............................................................................. 3 - 5