Kontron CP932 - Manual (Page 35)

CP932 Functional Description
ID 30048, Rev. 01 © 2005 Kontron Modular Computers GmbH Page 2 - 9
3004
8.01.UG.VC.050622/19130
1
P R E L I M I N A R Y
2.5.3 ATX Power Interface
The 4-pin ATX power connector is only available on the five-channel variant of the CP932 and
is used for connecting the ATX power supply to the CP932. This connector may only be used
if the CompactPCI connector, J1, is not connected to the power supply.
Figure 2-4: ATX Power Connector J2
Warning!
Either the CompactPCI connector or the ATX power connector may be used at
the same time. Failure to comply with the above may result in damage to your
board.
Table 2-3: ATX Power Connector J2 Pinout
PIN SIGNAL
4 +5V
3 GND
2 GND
1 NC
Warning!
Either the ATX power connector or the CompactPCI connector may be used at
the same time. Failure to comply with the above may result in damage to your
board.
4
3
2
1