Kontron CP3002 uEFI - Manual (Page 22)

Main Setup CP3002/-RC/-RA uEFI BIOS
Page 16 ID 1042-8946, Rev. 3.0
P R E L I M I N A R Y
2.5.5.3 Data Bits
Default setting: 8
2.5.5.4 Parity
Default setting: None
2.5.5.5 Stop Bits
Default setting: 1
2.5.5.6 Flow Control
Default setting: None
2.5.5.7 Recorder Mode
Default setting: Disabled
SETTING DESCRIPTION
7 Use one of these settings to specify the number of data bits per frame.
8
SETTING DESCRIPTION
None Use one of these settings to select the parity for the serial port.
Even
Odd
Mark
Space
SETTING DESCRIPTION
1 Use one of these settings to specify the number of stop bits for the serial port.
2
SETTING DESCRIPTION
None Use one of these settings to specify the type of flow control to be used for this serial port.
Hardware RTS/CTS
SETTING DESCRIPTION
Disabled Use this setting the disable Recorder Mode.
Enabled Use this setting enable Recorder Mode.
When this setting is used, all control escape sequences are suppressed from the serial
redirection output. This may lead to a misformatted screen output but makes automatic
storage of the serial console output easier.