Cp3002 introduction – Kontron CP3002 User Manual
Page 31
CP3002
Introduction
ID 1042-9252, Rev. 2.0
Page 1 - 11
P R E L I M I N A R Y
Interfaces
CompactPCI
Compliant with CompactPCI Specification PICMG® 2.0 R 3.0:
•
System master operation
•
32-bit / 33 MHz master interface
•
3.3 V or 5 V (universal PCI interface)
•
Support for up to seven peripheral slots (7x REQ/GNT signals)
When installed in a peripheral slot, the CP3002 is isolated from the Compact-
PCI bus. It receives power from the backplane and supports rear I/O.
CP3002 removal under power:
When installed in a peripheral slot, the CP3002 supports hot plugging on
the power interface through a dedicated power controller, but not on the
PCI interface.
Hot swapping of peripheral boards controlled by the CP3002:
When installed in the system controller slot, the CP3002 supports the hot
swapping of other boards. Individual clocks for each slot and Enum signal
handling are in compliance with the PICMG 2.1 Hot Swap Specification.
The CP3002 itself, however, is not hot swappable. When installed in the sys-
tem controller slot, the system must be powered down in order to replace the
board.
Rear I/O
The following interfaces are routed to the rear I/O connector J2:
•
COMA and COMB (3.3V LVTTL signaling)
•
2 x USB 2.0
•
VGA (analog)
•
2x Gigabit Ethernet
•
2x SATA
•
System management signals
•
Input for 5V standby power
•
General purpose signals
Gigabit Ethernet
Two 10 Base-T/100 Base-TX/1000 Base-T Gigabit Ethernet interfaces based
on the Intel® 82574L Ethernet PCI Express bus controller individually switch-
able to front I/O or rear I/O:
•
Dual RJ-45 connector on the front panel
•
Automatic mode recognition (Auto-Negotiation)
•
Automatic cabling configuration recognition (Auto-MDI/X)
•
Wake-on-LAN support
USB
Six USB ports supporting UHCI (USB 1.1) and EHCI (USB 2.0):
•
Two USB 2.0 ports on the front I/O
•
Two USB 2.0 ports on the rear I/O interface
•
Two USB 2.0 interfaces for the onboard high-speed I/O extension con-
nector
Table 1-1:
CP3002 Main Specifications (Continued)
FEATURES
SPECIFICATIONS