Electronics – Jeep 2015 Cherokee - User Guide User Manual

Page 82

Voice Texting — Want to dictate a personal message? Register with Uconnect

Access to take advantage of a new, cloudbased Voice Texting service, an enhance-
ment to Voice Text Reply.

Voice Texting allows you to compose a new text or reply to an incoming text message.
Before you attempt to use the Voice Texting feature, check to ensure you have the
following:
1. A paired, Bluetooth

enabled phone with the Message Access Profile (MAP). Not

all Bluetooth

enabled phones support MAP, including all iPhones

(Apple iOS).

Visit UconnectPhone.com for system and device compatibility information.

2. An active Uconnect

Access trial or paid subscription. Press the “Apps” button

on the lower right hand corner of the touchscreen to begin the registration
process.

3. Accept the “Allow MAP” profile request on your smart phone. (Please refer to

device manufacturer instructions for details).

To Send A Text Message:
1. Push the Uconnect

Phone Button

on the steering wheel.

2. Wait for the beep.
3. Say “Text.”
4. Uconnect

will prompt you “Say the phone number, or full name and phone type

of the contact you want to send a message to.”

5. Wait for the beep and say a contact that is in your phonebook, or a mobile phone

number that you would like to send the message to.

6. Uconnect

will prompt you “Please say the message that you would like to send.”

(If you do not hear this prompt, you may not have an active subscription with
Uconnect

Access).

7. Wait for the beep, and then dictate any message up to 140 characters. If you

exceed 140 characters, you will hear the following prompt: “Message was too
long; your message will be truncated.”

8. Uconnect

will then repeat the message back to you.

9. Uconnect

will prompt you: “To add to your message, say “Continue”; To delete

the current message and start over, say “Start Over”; to send the current message,
say “Send”; to hear the message again, say “Repeat”.

10. If you are happy with your message and would like to send it, wait for the beep

and say “Send”.

11. Uconnect

will then say “Sending your message.”

ELECTRONICS