Jeep 2015 Cherokee - User Guide - Manual (Page 147)

Voice Command Tips
• Speaking complete names (i.e; Call John Doe vs. Call John) will result in greater
system accuracy.
• You can “link” commands together for faster results. Say “Call John Doe, mobile,”
for example.
• If you are listening to available voice command options, you do not have to listen
to the entire list. When you hear the command that you need, push the
button on the steering wheel, wait for the beep and say your command.
Changing The Volume
• Start a dialogue by pushing the Phone button , then say a command for
example - "Help".
• Use the radio VOLUME/MUTE rotary knob to adjust the volume to a comfortable
level while the Uconnect ® system is speaking. Please note the volume setting for
Uconnect ® is different than the audio system.
NOTE:
To access help, push the Uconnect
® Phone button on the steering wheel and
say "help." Press the display or press either the Phone or VR button and
say "cancel" to cancel the help session.
Incoming Text Messages
After pairing your Uconnect ® system with a Bluetooth ® enabled mobile device with
the Message Access Profile (MAP), the Uconnect ® system can announce a new
incoming text message and read it to you over the vehicle’s audio system.
NOTE:
Only incoming text messages received during the current ignition cycle can be
viewed/read.
To enable incoming text messaging:
iPhone®
1. Press the settings button on the mobile phone.
2. Select Bluetooth
® .
• Ensure Bluetooth is enabled, and the mobile phone is paired to the Uconnect ®
system.
3. Select located under DEVICES next to Uconnect.
ELECTRONICS
145