Jeep 2015 Cherokee - User Guide - Manual (Page 43)

ELECTRONIC SPEED CONTROL
The Electronic Speed Control switches are located on the right side of the steering
wheel.
Cruise ON/OFF
• Push the ON/OFF button to acti-
vate the Electronic Speed Control.
CRUISE CONTROL READY will appear in
the Electronic Vehicle Information Center
(EVIC) or Driver Information Display
(DID) to indicate the Electronic Speed
Control is on.
• Push the ON/OFF button
a sec-
ond time to turn the system off.
CRUISE CONTROL OFF will appear in
the Electronic Vehicle Information Center
(EVIC) or Driver Information Display
(DID) to indicate the Electronic Speed
Control is off.
SET
• With the Electronic Speed Control on,
push and release the SET+ or SET-
button to set a desired speed.
Once a speed has been set a message CRUISE CONTROL SET TO MPH/KM will
appear indicating what speed was set. An indicator CRUISE will also appear and stay
on in the Electronic Vehicle Information Center (EVIC) or Driver Information Display
(DID) when the speed is set.
Accel/Decel
To Increase Speed
• When the Electronic Speed Control is set, you can increase speed by pushing the
SET + button.
The drivers preferred units can be selected through the instrument panel settings if
equipped. Refer to “Understanding Your Instrument Panel” in the Owner’s Manual
on the DVD for more information. The speed increment shown is dependant on the
speed of U.S. (mph) or Metric (km/h) units:
U.S. Speed (mph)
• Pressing the SET
+ button once will result in a 1 mph increase in set speed. Each
subsequent tap of the button results in an increase of 1 mph.
Electronic Speed Control Switches
1 — Push Cancel
2 — Push Set+/Accel
3 — Push Resume
4 — Push On/Off
5 — Push Set-/Decel
OPERATING YOUR VEHICLE
41