Jeep 2015 Cherokee - User Guide - Manual (Page 62)

PARKSENSE®
ParkSense® Front And Rear Park Assist
ParkSense ® can be enabled and disabled by pressing the ParkSense ® switch located
on the switch panel below the Uconnect ® display.
The six ParkSense ® sensors, located in
the rear fascia/bumper, monitor the area
behind the vehicle that is within the sen-
sors’ field of view. The sensors can detect
obstacles from approximately 12 in (30
cm) up to 79 in (200 cm) from the rear
fascia/bumper in the horizontal direction,
depending on the location, type and ori-
entation of the obstacle.
The six ParkSense ® sensors, located in
the front fascia/bumper, monitor the area
in front of the vehicle that is within the
sensors’ field of view. The sensors can
detect obstacles from approximately 12
in (30 cm) up to 47 in (120 cm) from the
front fascia/bumper in the horizontal di-
rection, depending on the location, type and orientation of the obstacle.
When an object is detected within 2 meters behind the rear bumper while the vehicle
is in REVERSE, a warning will display in the Electronic Vehicle Information Center
(EVIC) or Driver Information Display (DID). In addition a chime will sound (when
Sound and Display is selected from the Customer Programmable Features screen of
the Uconnect
® System). As the vehicle moves closer to the object, the chime rate will
change from single 1/2 second tone (for rear only), to slow (for rear only), to fast, to
continuous.
Refer to your Owner's Manual on the DVD for further details.
ParkSense® Switch
OPERATING YOUR VEHICLE
60