Jeep 2015 Cherokee - User Guide - Manual (Page 154)

UNIVERSAL GARAGE DOOR OPENER (HomeLink®)
• HomeLink ® replaces up to three hand-
held transmitters that operate devices
such as garage door openers, motor-
ized gates, lighting or home security
systems. The HomeLink
® unit is pow-
ered by your vehicles 12 Volt battery.
• The HomeLink ® buttons that are lo-
cated in the overhead console or sun-
visor designate the three different
HomeLink
® channels.
• The HomeLink ® indicator is located
above the center button.
Before You Begin Programming HomeLink®
Ensure that your vehicle is parked outside of the garage before you begin program-
ming.
For efficient programming and accurate transmission of the radio-frequency signal,
it is recommended that a new battery be placed in the hand-held transmitter of the
device that is being programmed to the HomeLink
® system.
To erase the channels, place the ignition switch into the ON/RUN position, then push
and hold the two outside HomeLink
® buttons (I and III) for up to 20 seconds or until
the red indicator flashes.
NOTE:
Erasing all channels should only be performed when programming HomeLink
® for
the first time. Do not erase channels when programming additional buttons.
If you have any problems, or require assistance, please call toll-free
1-800-355-3515 or, on the Internet at HomeLink.com for information or assistance.
Universal Garage Door Opener (HomeLink®)
ELECTRONICS
152