Oil life reset, What to do in emergencies – Jeep 2015 Cherokee - User Guide User Manual

Page 180

Oil Life Reset

• Your vehicle is equipped with an engine oil change indicator system. The “Oil

Change Due” message will flash in the EVIC display for approximately 10 seconds
after a single chime has sounded to indicate the next scheduled oil change
interval. The engine oil change indicator system is duty cycle based, which means
the engine oil change interval may fluctuate, dependent upon your personal
driving style.

• Unless reset, this message will continue to display each time you turn the ignition

switch to the ON/RUN position or cycle the ignition to the ON/RUN position if
equipped with Keyless Enter-N-Go™. To turn off the message temporarily, push
and release the MENU button. To reset the oil change indicator system (after
performing the scheduled maintenance), refer to the following procedure:

Vehicles Equipped With Passive Entry

Without pushing the brake pedal, push the ENGINE START/STOP button and cycle
the ignition to the ON/RUN position (Do not start the engine).
1. Push the

OK button to enter the EVIC menu screen.

2. Push and release the

DOWN

arrow button to access the ”Oil Life” menu

screen.

3. Push the

LEFT

arrow button or

RIGHT

arrow button to access the “VEHICLE

INFO” submenu.

4. Hold the

OK button to reset the “OIL LIFE” to 100%.

5. Push the

arrow button to exit the EVIC menu screen.

Vehicles Not Equipped With Passive Entry

Without pushing the brake pedal, cycle the ignition to the ON/RUN position (Do not
start the engine).
1. Push the