Hollywood Racks Swing Away (Boomer style) - Manual (Page 6)

2 Bike Add-on kit includes:
a. telescoping extension tube
b. locking top plate with locking knob and key
c. carriage bolt and nut
Attaching Add-on kit to convert from a two bike
carrier to a four bike carrier:
1. Remove cap, place on end of the 2 bike extension
2. Insert extension tube on to end of rack
3. Insert carriage bolt through top and bottom holes
4. Install nut, tighten securely
Limited One Year Warranty: This rack is warranted for a period of one year against defects in materials and
workmanship, effective from the date of purchase to the original purchaser. The manufacturer will repair or replace any
defective parts due to materials or workmanship. The manufacturer of this product shall not extend the warranty to 1)
any failure or malfunction of the product due to any modifications to the product; or 2) damages not attributable to
defects in materials or workmanship; or 3) damages resulting from improper installation on vehicle and / or attachment
of skis / snowboards on rack.
Consequential or Incidental Damages: The manufacturer shall not be liable for any consequential or incidental
damages in connection with the purchase, use or handling of this bike rack.
Purchaser’s Rights
: Some states do not allow the exclusion or limitation of consequential or incidental damages, and
the above limitations may not apply to you. This warranty gives you specific legal rights, and you have other rights,
which vary from state to state.
Hollywood Engineering, Inc. Customer Service Hours: M-F 8:00AM to 3:00 PM PST
PO Box 627 Gardena, CA 90248 US Patent# 6,123, 498
800-747-4085 FAX 310-516-8955 Made in USA and Taiwan
Email: [email protected] www.hollywoodracks.com 2/04 V5
WARNINGS:
1. Do not use this product on a trailer or a vehicle being towed behind another vehicle.
2. Drive very slowly on bumpy or dirt roads when using rack.
3. This product is intended for use on 2’ class 3 receivers only, NOT 1 ¼”
4. IF YOU HAVE A 1 ¼” HITCH, Do NOT use a 1 ¼” – 2” converter/adapter!
5. DO NOT USES THE OUTSIDE OR INSIDE FRAMES AS A STEP TO ACCESS
YOUR ROOF RACK!
Tip: The top pivot plate can be
pivoted to the left (driver’s side) for
easy storage while on your vehicle or
in the garage.
Pg. 6