Hollywood Racks PS10 Heavy Duty Dual Use Parking Stand - Manual

ASSEMBLY INSTRUCTIONS for
Heavy Duty Parking Stands
Models PS8 and PS10
“Double Sided” parking stand assembly
HOLLYWOOD RACKS
List of Materials:
Qty Description
1 Bike Grid (either 49” or 61”)
2 Floor Brace (either 49” or 61”)
2 Side Rails
Poly-bag containing:
8 Carriage bolts 3/8-16 x 3.25”
8
Self locking nuts 3/8-16
8 Flat Washers
12 Tube Plugs
Tools required: adjustable or 9/16” wrench
Assembly Procedure:
Check Contents of box prior to assembly
Determine if you are going to set up this parking stand
as either a “double sided” or single sided unit, then
refer to diagrams and instructions below.
Double sided PS8 parks 8 bikes, single sided PS8 parks 4 bikes
Double sided PS10 parks 10 bikes, single sided PS10 parks 5 bikes
Step 1: Starting with one side, align the bike grid to the side rail as
shown in Fig. 1a. Be sure to use the correct holes. Insert bolts as
shown, then attach washers and nuts to bolt. Finger-tighten nuts.
Step 2: Align floor brace “A” to the rear hole of the side rail as
shown. Insert bolt as shown, then attach washer and nut to bolt.
Finger-tighten the nut. Repeat for floor brace “B” using the forward
hole of the side rail. Note there are 3 unused holes in the side rail.
Step 3: Attach the other side rail to the other end of the floor braces
and bike grid. Insert bolts and attach washers and nuts.
Be sure to use the correct holes!
Step 4. Check that the parking stand is straight, then tighten all nuts
securely using the wrench. The assembled parking stand should look
like Fig. 1c. (note: model PS8 is shown in Fig. 1c).
Step 5: Insert tube plugs into unused holes as indicated in Fig. 1b.
Fig. 1b
Fig. 1c
Fig. 1a