General Hydroponics AF20 - Manual (Page 3)

ASSEMBLY
STEP 1
Insert the Drain Valve into the Reservoir grommet
while supporting the grommet from the inside.
Attach the Reservoir Lid as pictured and remove the
tear away strip.
STEP 2
Connect the Pump
line to the Mag Drive
Pump outlet (hand
tightening should be
sufficient). Place the
pump assembly into
the Reservoir and
feed the power cord
thru the center access
hole in the Reservoir
Lid followed by the
Pump line.
STEP 3
Assemble the SnapStand support stand by
sliding the SnapStand Legs into the SnapStand
Bases and the SnapStand Cross Fittings. Snap
the SnapStand Support Tube into SnapStand
Cross Fittings. Place the Growing Chambers on
the SnapStand support stand and reservoir so
that the drains are aligned with the outer holes
in the Reservoir Lid. Remove the Laser Spray
Lines and DLT from the Growing Chambers
and install the Laser Spray Lines by following
the directions provided with the Laser Spray
Lines.
pull tab
drain valve