Gastroback 41409 Design Mincer Advanced (standard size 8) User Manual

Page 9

Firmly screw the closing ring on the worm housing and

tighten by hand by turning it clockwise (picture G).
ATTenTIOn: Pay attention not to cant the screw. If the screw

cants the screw thread gets damaged. Do not tighten the screw

too much as this can cause damage to the motor. If the

screw does not turn easily use the provided spanner for help and

put some sunflower oil (or other edible oil) on the screw before

mounting.
6.

Place the feed pan onto the worm housing and place the

pusher into the opening of the feed chute (picture H).
The appliance is ready for operation.

Assembling for making sausages

Assemble the appliance according to the instructions ›assem-

bling for mincing‹ step 1 and 2.
2.

Take the adaptor disc (picture I) and place it on the axis of the

worm. The rounded end has to face away from the worm when

attaching. If necessary turn the adaptor disc a little bit until the

arresting pin of the worm housing locks precisely into the cor-

responding recesses of the adaptor disc.
IMPORTAnT: If the tools overlap the edges of the worm

housing the worm is not placed all the way inside of the worm

housing. Turn the worm a little bit to make it fit inside but do

not use force. If mounted correctly the adaptor disc is flush with

the front of the worm housing and the axis of the worm is visible

outside 5 mm of the adaptor disc.
3.

Place the sausage attachment on the worm housing (picture

J) and fit the closure ring over the sausage attachment. Firmly

screw the closing ring on the worm housing and tighten by hand.
ATTenTIOn: Pay attention not to cant the screw. If the screw

cants the screw thread gets damaged. If the screw does not

turn easily use the provided spanner for help and put some

sunflower oil (or other edible oil) on the screw before mounting.
6.

Place the feed pan onto the worm housing and place the

pusher into the opening of the feed chute.
The appliance is ready for operation.

Operating - mincing meat

The mincer operates absolutely dependently and clean. If any problems should occur while

operating act upon instructions ›Trouble shooting‹.

wARnInG:

In the case that liquid runs over the mincer while operating turn the mincer

off immediately and pull the plug. Clean and dry the appliance according to the instructions

›Care and cleaning‹.