Gastroback 41409 Design Mincer Advanced (standard size 8) - Manual (Page 13)

Possible problem Easy solution
After cleaning the motor does start again when
turning the appliance ON. • Is the power cord plugged in?
• The motor might be blocked with some hard substance (for example
a bone). Turn the appliance off immediately and pull the plug.
• Disassemble and clean the appliance. Operate according to the
instructions ›Care and cleaning‹.
• If the problem is not solved after the cleaning, take the appli-
ance for technical maintenance and repair to an authorised service
center.
The mincer blocks up permanently while
operating. • To ensure that the mincer does not seize, never operate it under
excessive pressure. Operate in a slow and constant pace. Do not
try to rush the procedure by pushing down the meat with force.
• For mincing hard ingredients really fine start with the grinding disc
with the bigger holes. Mincing the second time use the finer grinding disc.
The worm housing moves while operating. The closing ring loosened. Turn the appliance off immediately. Assemble
the worm housing according to the instructions ›Assemble for mincing‹.
The mince leaks out at the side of the closing
ring. The closing ring is not screwed on tight enough. Turn the appliance off
immediately and then pull the plug. Tighten the closing ring but do not
overwind the winding. If the problem still occurs disassemble and clean
the appliance.
CleAR A BlOCKInG
If the worm housing is blocked no mince comes out of the mincer while operating or the motor stops
moving automatically because of the overload protection.
ATTenTIOn: If a blocking occurs turn off the appliance immediately. Clear the problem
before turning on the motor again.
1.
Turn the appliance off and take the pusher out of the feed chute.
2. If the motor stopped running because of overloading, turn the appliance off and wait few
minutes to allow the motor to cool down.
3.
Turn the control switch to reverse and let the motor run in reverse mode for a few seconds.
The worm will turn backwards and loosen the blockage. The appliance will only run in reverse
mode as long as you hold on to the control switch.
ATTenTIOn: If the motor does not start moving backwards immediately turn off the
appliance and pull the plug. Disassemble and clean the appliance.
4.
After a few seconds in reverse mode turn the appliance off and wait a few
seconds for the motor to stop running completely. Turn the control switch
to ON. If the appliance still does not run smooth or the blockage occurs
again, turn the appliance off (by turning the control switch to STANDBY), pull
the plug and clean the appliance according to the instructions in chapter
›Care and Cleaning‹.
29