Trouble shooting guide – Gastroback 41409 Design Mincer Advanced (standard size 8) User Manual

Page 12

Take the closing ring of the worm housing and take the accessories (worm, crossed-blade

knife and grinding disc or the sausage filling attachment and the adaptor disc) out of the

worm housing.
Tip: If the tools got stuck knock the mincer carefully on a stable cutting board. The grinding disc

should be facing up.
ATTenTIOn: Be careful not to damage your bench top, the cutting board or the mincer.
6.

Remove meat residues.

Operate as described:

ATTENTION: Never put the motor housing or the accessories in the dishwasher

or use abrasives for cleaning! This will cause discolouration and corrosion

and damage the motor.
7.

Wash all parts thoroughly in warm soapy water. Do not use aggressive detergents. Soak

parts with desiccated food leftovers a few minutes in warm soapy water and use a nylon clean-

ing brush or cleaning sponge for cleaning. Rinse all parts with running water and dry them

accurately.

wARnInG:

Ensure that the switch and power cord do not come into contact with

water! Should this inadvertently happen, all parts must be completely dry before the appliance

is used again. Never let water or other liquids run into the motor housing. Never clean the

power cord or the motor housing in the dishwasher, poor liquids over the appliance or douse

or dip it in water or other liquids. In case that water or other liquids ran into the appliance

while operating turn STANDBY the appliance immediately, pull the plug and dry the appliance

with a clean cloth.
8.

The motor housing must only be wiped clean with a moist cloth. Do not clean the motor

housing under flowing water, nor should it be immersed in water! Do not use alcohol, ben-

zine, etc.!
9.

Grease the grinding disc and knife with salad oil to prevent air corrosion.

TROuBle ShOOTInG GuIDe

Always clear blockage according to the following instructions. For the case that you are unsuc-

cessful take the appliance to an authorised specialist reparation shop.

Possible problem

Easy solution

The mince is not fine enough.

Use a smaller grinding disc and/or mince the ingredients more then
once.

There are still ingredients in the feed chute
but no mince is coming out of the mincer.

The mincer is blocked. Turn the appliance off immediately and operate
according to the instructions ›Clear a blocking‹.

The motor stops running while operating.

The overload protection might got activated. Turn the appliance off
mmediately and operate according to the instructions ›Clear a blocking‹.