Gastroback 42820 Design Bread Maker Plus - Manual (Page 23)

54 55
4. Take the kneading paddle out of the bread pan.
If the kneading paddle sticks to the drive shaft and is hard to remove, fill the bread pan with
hot dishwater for approx. 30 minutes. Then try again.
Cleaning the Appliance
IMPORTANT: Do not immerse the appliance, power cord or bread pan in water or other
liquids to avoid damage. Do not clean the appliance or any part of it in an au-
tomatic dishwasher to avoid damage. Do not use any chemical agents or thinners for
cleaning the Bread Maker.
1. Clean the heating compartment and lid using a wet cloth or a slightly wet soft sponge.
Ensure that no fluffs or other particles remain on the heating elements.
2. Wipe the exterior of the appliance and power cord with a soft damp cloth. Thereafter,
polish with a dry cloth.
IMPORTANT: Do not immerse the bread pan in water or other liquids to avoid damage.
3. Clean all surfaces of the bread pan and the kneading paddle with warm dishwater.
If the opening in the bottom of the kneading paddle is clogged, you should soak the kneading
paddle for some minutes in hot dishwater. Thereafter clean it carefully using a small bottle
brush. Do not use any chemical cleaning agents or thinners to clean the bread maker.
4. Dry all parts thoroughly. Thereafter leave all parts dry naturally for at least 1 hour, where
they are out of reach of young children.
5. Reassemble the appliance after cleaning as described below.
Reassembling the Appliance
It is good advice to reassemble the appliance after cleaning. This way, you avoid damage to
the parts of the appliance and the parts cannot get lost.
IMPORTANT: Before reassembling the appliance, always ensure that the parts of
the appliance are clean and completely dry. This is crucial especially for the heating
compartment and exterior of the bread pan. Otherwise, moisture could get onto the heating
elements and cause risk of overheating and electric shock.
1. Insert the kneading paddle into the bread pan.
2. Insert the bread pan into the heating compartment.
For this, put the bread pan into the centre of the heating compartment. Then turn the bread
pan until it settles down on the coupling of the kneading works. Turn the bread pan clockwise
until it locks on the coupling
3. Reassemble the lid: Insert the tappets on the hinges of the lid into the respective openings
at the upper side of the housing. Then press the lid down. When closing the lid, there may be
no slit between lid and housing.
4. You may store the accessories of the appliance (yoghurt container, measuring cup, measu-
ring spoon) in the bread pan.
5. Close the lid.