Gastroback 42820 Design Bread Maker Plus - Manual (Page 22)

54 55
Unusual information is shown on the screen.
Problem Possible Reason The Solution
H:HH
(after starting the
program)
The temperature is too
high.
Immediately press the START/STOP button to
stop the program, and unplug the appliance.
Then open the lid and let the Bread Maker
cool down completely before using it again.
L:LL
(after starting the
program)
The temperature is too
low.
The ambient temperature should not be be-
low 15 °C.
E:E0
(after starting the
program)
The temperature probe
failed.
Bringen Sie das Gerät in eine autorisierte
Fachwerkstatt zur Reparatur.
E:E1 The temperature probe
failed.
Send the appliance to an authorized service
centre for repair.
Care and Cleaning
WARNING – RISK OF BURNS
Always ensure that the appliance is out of reach of young children. Always
switch OFF the appliance (START/STOP button), then unplug the appliance, and wait until the
appliance cooled down (up to 40 minutes), before moving or cleaning the appliance. Do not
attempt to move the appliance during operation.
The surfaces of the bread pan and kneading paddle have a non-stick coating. Do not scratch
or cut on the non-stick coatings. Do not use any abrasive cleaners or corrosive chemicals (e.g.
bleach) for cleaning the appliance or any parts of it, to avoid damage to the surfaces. Do not
use any hard or sharp-edged objects for cleaning any surfaces of the appliance. Additionally,
particles derived from scoring pads could get into the interior of the appliance, causing ha-
zard due to overheating, fire and/or electric shock.
Ensure to protect the appliance against splashing water and moisture. Do not immerse the
appliance, or power cord in water or any other liquid, to avoid hazards due to electric shock
and damage. Do not spill or drip any liquids on or in these parts to avoid risk of fire and
electric shock. Do not clean the appliance or any part of it in an automatic dish-
washer. Do not use violence!
Disassembling the Appliance
1. Switch OFF the appliance by pressing the START/STOP button for approx. 2 seconds. Then
unplug and leave the appliance cool down to room temperature (at least 40 minutes).
2. For easy cleaning, you can remove the lid:
For this, open the lid and pull it upwards out of the hinges.
3. Take the bread pan out of the heating compartment.
For this, turn the bread pan counterclockwise until you can easily lift it out of the heating
compartment.