Gastroback 42820 Design Bread Maker Plus - Manual (Page 21)

52 53
10. Shortly press the START/STOP button to start the program. An acoustic signal sounds as
soon as the program has been completed.
11. Leave your homemade yoghurt cool down. Then store in the refrigerator.
Solving Problems
If any problems occur during operation, you will find solutions in this section. Further informa-
tion on processing your food is given in section Tips for Best Results.
Problem Possible Reason The Solution
The kneading
paddle sticks
inside the bread
pan after baking.
Remainders of dough
clog the drive shaft in
the bread pan.
Add hot water to the bread pan and turn the
kneading paddle to loosen encrusted materi-
al underneath.
The bread is moist
and too soft.
If the bread cools down
in the Bread Maker, it
could become moist due
to condensate.
Take out the baked bread in time. Store your
bread for instance in a bread bin.
The dough does
not get stirred,
even with the
motor running.
Kneading paddle and/
or bread pan are not in-
stalled properly.
Make sure that the kneading paddle and
bread pan are positioned properly.
The power fails
while a program
is running.
– In case of power failure for up to 10 mi-
nutes, the bread maker will run the last im-
plemented program until completion, after
being live again.
– On power failure for more than 10 minutes,
you must re-start.
Raisins, cho-
colate pellets,
fruits and similar
ingredients get
crushed in the
appliance.
To avoid the chopping of ingredients such as
fruit, add these to the dough only after the
signal is sounded.
You cannot
activate the timer
function. The
buttons TIME+
and TIME– are
inactive.
You have selected a pro-
gram intended for fresh
ingredients, such as milk
or eggs. The timer func-
tion is not available with
these programs.
The programs 6, 7, 10, and 11 do not allow
any timer operation. If suitable for your reci-
pe, select another program.
On the LCD
screen, the
displayed time
flashes.
You have selected the
program BAKE or
YOGHURT. With these
programs, you can ad-
just the processing time.
Press the buttons TIME+ and/or TIME– to
adjust the desired processing time. Alterna-
tively, select another program.