Gastroback 42580 Vita-Spin-Fryer - Manual (Page 19)

43
7. Carefully take out the oil container to avoid spilling the oil. Push the container release slider
to the right side. Then turn the oil container counterclockwise to the stop, and lift it carefully up
and out.
8.
Pour the oil into a suitable container.
9. Remove the dripping cup from the rear of the appliance.
10. Dispose degraded oil in a closed container in domestic refuse. DO nOt dispose oil in the
sink!
Cleaning the appliance
CautIOn: Do not use any abrasive cleaners, cleaning pads (e.g. metal scouring pads), or
any corrosive chemicals (e.g. bleach) for cleaning the appliance or any parts of it, to avoid
damage to the surfaces. Do not use any hard or sharp-edged objects for cleaning. Do not
immerse the housing, control unit, or power cord in water or any other liquid. Do not spill
or drip any liquids on or in the housing, control unit, or power cord to avoid risk of fire and
electric shock. Do not clean housing, control unit, or power cord in an automatic
dishwasher. Do not use violence!
1.
It is a good idea to wipe residues of oil from the oil container first. For this, you may use
paper towels or something similar.
2.
Basket, lid, filter cover, oil container, and dripping cup can be washed in warm soapy wa-
ter. However, you can clean these parts in an automatic dishwasher. As far as possible, use
the upper tray.
CautIOn: Do not insert the control unit into liquids. Clean the heating rods and wires of the
temperature probe with special care to avoid damage. Do not drip any liquids in the housing
of the appliance or on the control unit or power cord.
3.
Wipe the control unit and heating rods carefully with a cloth or SOFt brush, slightly dam-
ped with warm dishwater. Thereafter, wipe with clear tap water. Doing so, ensure not to spill
water on the black body of the control unit.
4.
Clean the inner and outer surfaces of the housing, using a cloth, damped with a little warm
dishwater. Ensure not to drip any liquids into the housing of the appliance.
warnIng: Always ensure that the appliance and all parts of it are out of reach of
young children.
5.
Dry the parts thoroughly after cleaning, and thereafter let dry naturally for approx. 1 hour,
where it is out of reach of young children.
6.
Reassemble the components to the appliance as described below. Ensure that the lid and oil
container are free from water after cleaning and before reassembling.
reassembling the appliance
It is good advice to reassemble the appliance after cleaning. Thus
you avoid damage to the parts of the appliance and the parts can-
not get lost. Always let the parts of the appliance dry completely,
before reassembling.
1.
Make sure that the container release slider is in open position
(pulled outward, see Figure D).
figure D