Gastroback 42580 Vita-Spin-Fryer - Manual (Page 14)

38
Additionally, too much oil could lead to failure of the spinning process and damage of the
centrifuge, because the basket will stay in oil during spinning.
To avoid splashes, lock the basket in the upper position for adding food. Then close the lid
and always lower the basket slowly into the oil to avoid overflowing. If oil has
run out, immediately unplug the appliance and leave it cool down. Then clean the appliance
to avoid risk of fire and electric shock.
Keep the lid closed as far as possible, during operation to avoid damage due to splashes and
hot steam. Do not use violence for opening the lid or lifting up the basket. Lid and basket are
locked securely for operation. Thus, always press the opening/release button to release these
safety interlocks.
Exclusively use the appliance for processing food that is fit for comsumption.
preparing the appliance
1. Press the opening button at the right upper side of the housing; then open the lid.
2. Hold the basket at the handle, and with the basket release button at the top of the handle
pressed, lift the basket up and out.
3.
Ensure that the appliance is assembled correctly, and oil container, lid, heating rods, and
basket are completely dry (see: ›Reassembling the Appliance‹).
CautIOn: Oil container, lid, heating rods and basket must be completely dry before use.
Moisture could make hot oil froth and splash vigorously, when opening the lid. Additionally,
always ensure that the filling level in the oil container is between the filling level marks MIN
and MAX. Too little oil could lead to overheating; too much oil could overflow the brim of
the oil container, causing injuries and damage. Additionally, too much oil could prevent a
successful spinning process.
4.
Pour good quality oil (e.g. rapeseed, corn or groundnut oil) into the oil container. ensure
that the filling level is between the mIn and maX filling level marks indicated
on the oil container. You will need approx. 2.3 Litre.
5.
At the rear of the appliance, insert the dripping cup in the opening under the hinge of the
lid.
tip: The dripping cup prevents hot oil and condensate from running down onto the table/
counter, when opening the lid.
6.
Close the lid.
Frying
1. Prepare your food for frying. Cut your food into pieces fitting for the basket of the fryer.
Damp food must be dried first. Remove any loose ice from frozen food (see also: ›Tips for Best
Results‹).
2.
Ensure that the SPIN timer of the centrifuge is set to 0. Turn the temperature dial to the MIN
position.
tip: As far as possible, you should avoid turning back the SPIN timer and cooking timer. It is
better to wait, until the set time elapsed. The timers continue running even if the appliance is
disconnected from the power supply.
3.
Connect the appliance to the power supply (see: ›Important Safeguards for Electrical Appli-
ances‹). The red power indicator and the green heater indicator illuminate.