Clarion MAX685BT - Manual (Page 74)

72
MAX685BT
English
INSTAL
LATIO
N
MAN
UAL
2. BEFORE STARTING
1. This set is exclusively for use in cars with a
negative ground 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery “
-” terminal
before starting. This is to prevent short circuits
during installation. (Figure 1)
3. PACKAGE CONTENTS
1 Main unit
2 Manuals
Owner’s manual & Installation manual
Warranty card
3 Power supply cord
4 Rca pin cord
5 Bag for accessories (No. 1)
Flat head screw (M5 u 8) ............................. 8
Sems hexagonal bolt (M5 u 8)..................... 8
Electro tap
6 Bag for accessories (No. 2)
Rubber cap (for RCA pin cord)
7 Remote control unit
8 Battery
(for remote control unit)
9 Finisher
4. GENERAL CAUTIONS
1. Do not open the case. There are no user-
serviceable parts inside. If you drop anything
into the unit during installation, consult your
dealer or an authorized Clarion service
center.
2. Use a soft, dry cloth to clean the case. Never
use a rough cloth, thinner, benzine, or alcohol,
etc. For tough dirt, apply a little cold or warm
water to a soft cloth and wipe off the dirt
gently.
Car battery
Figure 1