Gastroback 40123 Design Juicer User Manual

Page 8

Assembling your Design Juicer

Operating your Design Juicer

WARnInG: Make sure the appliance is

completely assembled and that there are nor

foreign objects in the feed chute before putting

the plug into the power point.
never put fingers, wooden spoons or other

foreign substances (such as hair, clothing, brush-

es, cloth) into the feed chute.
Always turn the appliance off and wait for the

motor to stop moving before removing the lid

of the juicer.

slide the food pusher all the way down the feed

chute (picture 5a).

Step 6:

Place the pulp container into position by tilting

the motor base slightly to the right. insert the

container under the juicer cover on the left-hand

side ensuring it is supported by the container

support extending from under the motor base

(picture 6).
nOTe: To minimise cleaning, line the pulp con-

tainer with a plastic freezer bag to collect the pulp.

Pulp can then be used in other dishes, or as compost

for the garden or discarded.

Step 7:

Place the juice jug underneith the spout (picture 7).

Keep the working place clean and dry. Do not

let any liquids or water run into the motor block.
Do not put any cloth or napkins underneath

the appliance to avoid endangering by fire

and voltage. in case that water or other liquids

ran into the motor block while operating turn off

the appliance immediately, pull the plug and

dry the appliance with a clean cloth. Operate

according to the instructions ´Trouble shooting

guide`