Gastroback 40123 Design Juicer - Manual (Page 10)

40
Disassembling your Design Juicer
WARnInG: Always turn the appliance ‘OFF’
and pull the plug when the appliance is not in
use or when disassembling, moving or cleaning
the appliance. never let water or other liquids
run into the motor block. never clean the line
cord or the motor block in the dishwasher, poor
liquids over the appliance or douse or dip it in
water or other liquids.
Step 1:
Push the ‘ON/OFF’ button on the juicer to ‘OFF’
and then switch ‘OFF’ at the power outlet and
unplug. IMPORTAnT: Wait for the filter bas-
ket to stop spinning before continuing to step
2 carefully remove the pulp container by tilt-
ing the pulp container slightly to the right and
unlatch it from under the juicer cover and the
container support extending from under the motor
base (picture 1).
Step 2:
Pull the locking arm back over the grooves on
either side of the juicer cover (picture 2/3).
Move the locking arm down.
Step 3:
Lift the juicer cover off the juicer (picture 4).
1
4
3
2