Assembling your design juicer – Gastroback 40123 Design Juicer User Manual

Page 6

Assembling your Design Juicer

Step 1:

Place the filter bowl surround on the motor block

(picture 1).

Step 2:

WARnInG: Handle the units with care and

do not use any force. Pay attention to the sharp

blades on the stainless steel micro mesh filter

and the feed chute to avoid injury. Always

completely assemble your juicer before you

plug the plug into the power point.

ATTenTIOn: ensure the stainless steel filter

basket is clean before assembling. Any dehumidi-

fied left over food on the basket will block the

fine mesh holes. if necessary remove excess

fibre build up (from fruit or vegetables) accord-

ing to the instructions ´care and cleaning`.

Align the arrows on the stainless steel filter basket

with the arrows on the motor drive coupling

and push down until it clicks into place. ensure

the stainless steel filter basket is fitted securely

inside the integrated pulp container and onto

the motor base (picture 2).

Step 3:

Place the juicer cover over the stainless steel filter

on top of the filter bowl surround (picture 3). The

feed chute has to be positioned in the middle

of the filter basket and the pulp spouting of the

cover has to face away from the interlocking safety

arm.