ETS-Lindgren 7606 Coil Antenna/Shielded Coil - Manual (Page 24)

Assembly for Calibration
For test setup calibration, Model 7605 and Model 7606 are assembled together.
When assembled, the two loops are parallel to each other and coaxial with their
centers precisely 5 cm apart.
Do not over tighten the nylon bolt. Tighten it to
only finger tight; do not use a wrench.
Over tightening may cause the bolt to break,
blocking the bolt hole and making calibration
impossible.
1. Place the Model 7606 into the slot
in the body of the Model 7605, with
the BNC connector positioned
outside Model 7605 and pointing
upward.
2. Insert the 3/8–16 nylon bolt. Tighten
to finger tight.
24 | MIL-STD-462D Method RS101 Testing