CDA GB RV 701 SS User Manual
Page 36
36
Gas Connection
Cat: II 2H3+
The gas supply must be connected to the gas inlet which is located at the rear of the appliance (see figure
41).
If the connection pipe cross the cooker, it must be positioned under the cooker rear protection.
To screw the connecting tube operate with two spanners (fig. 40).
After connecting to the mains, check that the coupling are correctly sealed, using soapy
solution, but never a flame.
Fig. 40
gas pipe
cooker
rear protection
1/2” BSP (male)
Fig. 41