Coral Industries Style Bypass (3/16 Frameless) - 20R1-G - Manual (Page 4)

20R1-G 1/07
Measure full height of glass and determine the
midpoint. At midpoint, wrap one piece of bracket vinyl
(E) around door glass, holding in position while slipping
one door bracket assembly in place over vinyl.
(Two
thicknesses of bracket vinyl may have been included with your
unit. Use the vinyl that makes a snug fit between door bracket
and glass.)
Insert towel bar (D) onto end of towel bar bracket. Slip
door bracket assembly in place for opposite end,
inserting bracket into end of towel bar. Repeat for
remaining panel.
Mount rollers (F) to roller fins using 8-32 x 3/8" truss
head screws (M). Rollers are to be mounted on same
side of doors as towel bars and at the midpoint of slots.
Rollers may be positioned up or down in slots to adjust
for out of plumb situations.
Door
Bracket
Assembly
Roller
Bracket
Vinyl
8-32 x 3/8"
Truss Head
Screw
M
Roller Fin
Towel bar for outside
panel faces outside of
shower, while towel bar
for inside panel faces
inside of shower.
G
6 Towel Bar
(D)
/ Towel Bar Bracket Kit
(E)
Towel Bar
D
F
E
E
The use of a caulking compound will assure a water-
tight seal. Seal unit by applying caulk along outside
edge of enclosure where metal and bath meet,
especially where sill meets tub.
If desired, caulk inside of enclosure where jambs meet
walls.
Caulk
OUTSIDE OF SHOWER
Caulk
Lift door panel into header with towel bar facing inside of
bath. Seat rollers on roller track while guiding bottom of
door into sill guide.
Repeat for remaining door, hanging panel with towel bar
facing outside of bath.
Adjust rollers up or down as needed in roller fin slots to
compensate for out-of-plump conditions, allowing
panels to hang straight.
8 Hanging Door Panels
Inside
Panel Outside
Panel
Header
Sill
Guide
OUTSIDE
OF
SHOWER
A
H
C
Inside
Panel
Header
OUTSIDE
OF
SHOWER
C
9 Caulking
Rollers
(F)
7