Coral Industries 6000 Bypass with DTB Towel Bar - 2621-G - Manual (Page 2)

2621 6/99
INSTALLATION INSTRUCTIONS
Before starting installation of your new enclosure, carefully read all
instructions and lay out parts to become familiar with their identity.
Do not try to cut the mirrors or glass used in this enclosure.
Tempered glass and mirrors will disintegrate if cut.
Mounting of this unit on tile requires the use of anchors. Special care must be taken not to crack the tile. Before drilling holes in
the tile, lightly chip glazed surface of tile at the desired locations. Drill holes using a 3/16" masonry drill bit. Insert anchors into the
holes making certain that ring on large end of anchor meets the surface of the tile.
CLEANING
Cleaning and care of your enclosure is important to its lasting beauty. We suggest using a nonabrasive liquid cleaner.
Never use scouring powder or pads.
SEALING
The use of a caulking compound can assure a water-tight seal when applied along outside edge of the enclosure where metal and
bath meet. If desired, caulk inside of enclosure where jambs meet walls.
Anchors are furnished with every enclosure. However, the use of anchors is not recommended when attaching your enclosure to
a fiberglass unit or wall surrounds with board reinforced mounting areas. Mounting holes in this case should be drilled with a
1/8" drill bit.
USE OF ANCHORS
Measure wall to wall opening at tub level and cut sill
(A) to that measurement. If necessary, file sharp
corners of sill to fit contour of your unit.
Slide vinyl track guide (E) into small groove on
upright of sill. Trim end flush with edge of sill.
Locate center of sill. Position guide (I) at center of sill
with curved leg fitting over curve of sill, and back of
guide fitting under small lip on back upright of sill.
Drill through hole in guide using 1/8" drill bit. (Chrome
and gold units include a self-drilling screw which does not
require a pilot hole.)
Secure guide to sill with 8A x 3/8" pan head screw
(M).
1
Measure
Vinyl Track
Guide
Sill
E
Guide
Sill
Sill
A
8A x 3/8" Pan
Head Screw
INSIDE OF BATH
Sill
M
Sill
Sill
A
Place guide at
center of sill.
Sill
I