Coral Industries Provincial Prestige Bypass with Towel Bars and LSL Sill - 2PG1 (Most Common) - Manual (Page 6)

2PG1-GP 3/11
Mount rollers (H) to top channel of doors using
8-32 x 3/8" truss head screws (I). Rollers are to be
mounted on same side of doors as towel bars and at the
midpoint of slots. Rollers may be positioned up or down
to adjust for out of plumb conditions.
Roller
8-32 x 3/8"
Truss Head
Screw
9
Rollers
(H)
H
I
lower header over jambs until seated squarely on both
jambs.
attach header to jambs by drilling a 1/8" hole through
header into jambs on inside of tub near walls. Secure
using 8A x 3/8" truss head screws (J).
C
B
8A x 3/8"
Truss Head
Screw
Header
Jamb
J
InSIDE OF baTH
7
Header
(C)
8
Towel Bar
(K)
Towel bars from towel bar kit (K) are to be mounted
onto door panel through predrilled holes in glass. Towel
bar for outside panel faces outside of bath while bar for
inside panel faces inside of bath.
Towel bar kit comes with parts assembled in the order
they will be installed on glass. disassemble parts. Press
bushings into holes in glass. Trim as needed so that
bushings are flush with surface of the glass.
reassemble towel bar, plastic washers, and end cap
on door panel as shown. Allen wrench may be used to
aid in tightening by inserting into hole of end cap and
turning. repeat for remaining door panel.
Towel bar for outside panel faces
outside of bath while bar for inside
panel faces inside of bath.
outside of bath
k
Towel bar
Plastic
Washer
bushing
Plastic
Washer
end
cap