Coral Industries 6000 Swing Door/DPNL - 563 - Manual (Page 5)

563-GP 2/06
Measure from wall to wall over the top of both jambs
and cut header (C) to that measurement.
Position header so that long leg is toward inside of
shower. Lower into place over jambs and side
panels. This will provide stability while positioning
door stops and door.
OUTSIDE OF SHOWER
Header C
Long Leg
of Header
faces
inside of
shower
4 Header
(C)
Jamb
B
Measure
Side Panel
OUTSIDE OF SHOWER
Hinge Door Stop
OUTSIDE OF SHOWER
Header
Door
Panel
Magnetic
Door Stop
Header
C
E
Magnetic
Strip (facing
outside of
shower)
G
Side
Panel
Side Panel
OUTSIDE OF SHOWER
Door is normally
installed to open
nearest showerhead.
Door
Showerhead
C
Slide magnetic strip (G) into slot on magnetic door
stop (E). Trim ends even with door stop using
scissors.
Choose which will be the opening side of your door.
Door is normally installed to open on the side of unit
nearest to showerhead. Slide magnetic door stop
onto panel on opening side of door. Make certain that
the magnetic strip faces outside of shower.
Position hinge stop, which is attached to door panel,
onto opposite side panel. For safety purposes, door
should be installed to open out from shower.
If magnetic strips do not seal tightly, reverse
polarity by removing strip from door stop and
replacing it with the previous top end as the
bottom end.
5 Magnetic Door Stop
(E)
Hinge Door Stop / Door Panel