Code 3 WingMan with TriCore for 2009 Chevy Impala - Manual (Page 6)

6
This Product contains high intensity TriCore® devices. To prevent eye
damage, DO NOT stare into light beam at close range.
WARNING!
Flash Patterns
STANDARD LIGHT HEAD FLASH PATTERNS
PATTERN NO PATTERN DESCRIPTION
1
FAST ALTERNATING QUAD FLASH 100ms/25ms
2 PICKET FENCE SINGLE FLASH 200ms/25ms
3 ALTERNATING SINGLE FLASH 200ms/25ms
4 PICKET FENCE QUAD FLASH 100ms/25ms
5 PICKET FENCE SIX FLASH 75ms/25ms
6 SLOW ALTERNATING QUAD FLASH 150ms/50ms
7 SLOW ALTERNATING SIX FLASH 125ms/25ms
8 FAST ALTERNATING SIX FLASH 75ms/25ms
9 VARIABLE RATE PICKET FENCE, SINGLE FLASH
10 ALTERNATING QUAD FLASH, 80 FPM, NFPA COMPLIANT
11 CYCLE FLASH
12 SIMULTANEOUS QUAD FLASH, 75 FPM, NFPA COMPLIANT
Flash Pattern Changes
ARROWSTIK FLASH PATTERNS
PATTERN NUMBER PATTERN DESCRIPTION
1
2
3
4
5
6
7
8
9
10
11
12
Building, Fast Speed
Building, Medium Speed
Building, Slow Speed
Building, 3 Flash, Fast Speed
Building, 3 Flash, Medium Speed
Building, 3 Flash, Slow Speed
Traveling Ball, 3 Flash, Fast Speed
Traveling Ball, 3 Flash, Medium Speed
Traveling Ball, 3 Flash, Slow Speed
Build/Collapse, Fast Speed
Build/Collapse, Medium Speed
Build/Collapse, Slow Speed
TriCore
®
Light Head Flash Pattern
To change the flash patterns of the TriCore® Light Heads for either Standard or ArrowStik ® patterns, activate the
Light Bar in Level 1 or any ArrowStik mode and then momentarily touch the Green (Pattern Select) wire to +power.
Repeating this procedure allows the operator to cycle through the numerous flash patterns offered until the desired
pattern is achieved. Repeat for all modes as needed.
Note: Each ArrowStik mode must be set individually.
To reset the flash patterns to the factory default, activate the Light Bar in Level 1 or any ArrowStik mode and then
hold the Green (Pattern Select) wire to +power for approximately 4 seconds.
Note: 1-Resetting the Standard patterns will reset only the Level 1 flash patterns
2-Resetting the ArrowStik patterns in any ArrowStik mode will reset all ArrowStik flash patterns.
6 HEAD ARROWSTIK
®
W (2) OUTER LIGHT HDS FLASHING ALTERNATELY
The WingMan™ can be configured as a 6 or 8 head ArrowStik. To change the WingMan from an 8 head ArrowStik to a 6 Light
Head configuration with the (2) Outboard Light Heads flashing alternately, remove the mounting screws that attach the Wing-
Man's Cover to the Outer Panel to gain access to the printed circuit board inside (see the exploded view on page 7). Move the
Shunt Option Jumper (JP1) on the printed circuit board to the "OPTION JP1" position as shown below. When configured for a 6
head operation the (2) Outboard Light Heads will alternate during any ArrowStik mode. Carefully replace the WingMan's Cover
over the Outer Panel and replace the Cover Mounting Screws.
Note: Be extremely careful to replace the wiring such that you don't pinch a wire when you
replace the WingMan's Cover. Test the unit to be sure that it works properly.
<---------------"OPTION JP1" Jumper Position