beautypg.com

Warning, Step 1-removing sun visors, Step 2 remove the visor retaining clips – Code 3 SuperVisor with TriCore for 2009 Chevy Tahoe User Manual

Page 3

background image

3

Mounting Hardware - All mounting hardware is packed in a small box inside the main carton. There are four brackets used to mount

the Supervisor TL to the vehicle. These are discussed in detail later.

Utilizing non-factory supplied screws and/or mounting brackets and/or the improper

number of screws may result in loss of warranty coverage on the equipment.

WARNING!

FIGURE 1 FIGURE 2 FIGURE 3

Step 1-Removing Sun Visors

Begin the installation by removing the driver and passenger sun visors. Identify each visor with tape or other marking to indicate the

driver from the passenger side unit; they are not always identical. First remove the plastic visor pivot bracket cover by prying the cover

apart at the thin slit shown in Figure 1 with a thin instrument like a putty knife. There are small keeper tabs which hold the cover to

the pivot bracket (Figure 2 shows the locations of the tabs). You have to pry the slit open and pull the cover down and away from the

headliner at the same time. It helps to pull the edge of the cover outward and down in the area of each tab to help release the cover

from the pivot bracket. When one of the tabs is released, it is easier to release the cover at the other tab locations (Figure 3 shows the

cover removed). Next there are three screws that hold the pivot arm bracket of the sun visor to the headliner. Remove the three screws

using a small #15 torx screwdriver as shown in Figure 4. The screws do not have to be completely removed from the plastic pivot arm

bracket to release the pivot arm (see Figure 5). Unplug the visor vanity mirror light wire if the vehicle is so equiped (see Figure 6).

Step 2 Remove the visor retaining clips

Pry open the small cover on the sun visor retaining clip with a very small flat bladed screwdriver to gain access to the sun visor retain-

ing clip screw (see FigureS 7 and 8). Remove the single #15 torx screw that holds each clip in place as shown in Figure 9.

FIGURE 4 FIGURE 5 FIGURE 6

FIGURE 7 FIGURE 8 FIGURE 9