Maintenance, Flash control options – Code 3 PSE690 Remote Strobe Power Supply User Manual
Page 7

7
FIGURE E
FOR NFPA COMPLIANT INSTALLATION, SELECT QUAD
OR FIVE FLASH MODES
To have the ability to select the 8 available patterns, connect each control wire to a seperate powered
switch. Any of the flash patterns in Figure E can be selected by activating the corresponding switch(es).
WARNING: To achieve the maximum performance from your strobe tubes, do not mix Helix tubes and
Linear Tubes. Run all Helix or all Linear strobe tubes in power supply outputs #1,3,5, and run all Helix
on all Linear Strobe Tubes in power supply output 2,4,6 mixing strobe tubes will cause one type to
flash brighter than the other type and will reduce the life expectancy of the brighter flashing tube.
MAINTENANCE
The PSE-690 Remote Strove Power Supply has been designed to provide trouble free service. In case of
difficulty, refer to the Troubleshooting section. Periodic inspection of power supply wiring, and strobe light head
connections for shorted or open wires will assure trouble free operation. The primary cause of short circuits
has been found to be wires passing through firewalls, roofs, etc.
VIOLET YELLOW GREEN
BLUE
FLASH MODE
FLASH CONTROL OPTIONS
0
0
0
0
All Heads OFF
0
0
0
1
Quad Flash Heads 1 Alt 2
0
0
1
0
Quad Flash Heads 3,5 Alt 4,6
0
0
1
1
Quad Flash All Heads
0
1
0
0
Five Flash All Heads
0
1
0
1
Standard Double Flash All Heads
0
1
1
0
Fast Double Flash All Heads
0
1
1
1
Triple Flash All Heads
1
0
0
0
Cycle Flash All Heads
1
1
0
0
Cycle Flash All Heads
1
0
1
0
Cycle Flash All Heads
1
1
1
0
Cycle Flash All Heads
1
1
0
1
Cycle Flash All Heads
1
0
1
1
Cycle Flash All Heads
1
1
1
1
Cycle Flash All Heads
All other matrix combinations are OFF's
1 = 10-30 volt connection 0 = No power or ground connection