Code 3 PSE690 Remote Strobe Power Supply - Manual (Page 5)

5
FIGURE B
FIGURE C
NOTE: IT IS IMPORTANT TO FOLLOW THE CORRECT COLOR CODE
WHEN INSERTING THE PINS INTO THE AMP 3 PIN CONNECTORS.
4. Connect the cables to the strobe light heads.
5. Next, plug the other end of the cable into the Light Head socket (output) on the PSE-690 strobe power
supply. The location of the cable for each light head attached to the PSE-690 will be determined by the flash
mode selected. (see figure E on page 6)
POWER/CONTROL WIRE HARNESS ASSEMBLY
The Power/Control wire harness assembly consists of two 3 pin AMP connector with: 1 red, 1 black, 1 violet, 1
yellow, 1 blue and 1 green (see figure C). The Power/Control harness assembly must be connected to the
power/control socket(s) located on the PSE-690 strobe light power supply. Use 18 gauge wire to extend the
control harness wires to a customer supplied switch to complete the installation.
IMPORTANT: To extend the power (+) and
ground (-) wires, use the following as a guide.
1 to 10 ft. use 16AWG wire
10 to 20 ft. use 14AWG wire
20 to 30 ft. use 12AWG wire
30 to 50 ft. use 10AWG wire
Insert wires with female pins into
the proper locations in the female
Amp connector:
RED WIRE - Hole 1
BLACK WIRE - Hole 2
WHITE WIRE - Hole 3 Female Amp
Connector.
Insert wires with male pins into the
proper locations in the male Amp
connector:
RED WIRE - Hole 1
BLACK WIRE - Hole 2
WHITE WIRE - Hole 3
Male Amp connector to be mated
with the Amp output socket on
the Power Supply.
Amp wire harness attached to
Strobe light head.
6 3 4 5 1 2
POWER
VIOLET
BLACK (-) GREEN
YELLOW
CONTROL
BLUE
RED (+)
1
2
3