beautypg.com

Warning – Code 3 PSE460H Remote Strobe Power Supply User Manual

Page 5

background image

5

RED WIRE - (ANODE) POSITION 1

WHITE WIRE - (TRIGGER) POSITION 3

STRIP INSULATION TO EXPOSE
BARE WIRE AS SHOWN

FIGURE 3

AMP

®

3 PIN SOCKET HOUSING

PN 1-480303-0

AMP

®

SOCKET PIN

PN 60619-9

2. After the cables have been properly routed for each strobe head they will have to be terminated with the

three pin AMP socket housings provided. The cables are factory terminated with the proper AMP pins for
insertion into the housings, see Figure 3. If there is a need to re-terminate any wires, Figure 3 also
includes stripping and crimping information.

15 AMP FUSE FOR STROBE
POWER SUPPLY PROTECTION

POWER INPUT HARNESS

FLASH CONTROL HARNESS

STROBE HEAD OUTLET #4

STROBE HEAD OUTLET #2

STROBE HEAD OUTLET #3

STROBE HEAD OUTLET #1

FIGURE 2

WARNING!

!

It is very important to observe the pin locations and color on the three pin socket
housings. Improper connections could damage the remote strobe heads, see Figure 3.

NOTE: USE AMP HAND TOOL PART NO. 90124-2 OR EQUIVALENT TO CRIMP SOCKET PINS TO THE
WIRES.

CRIMP TO INSULATION ONLY

CRIMP OVER BARE WIRE

1/8 INCH

BLACK WIRE - (CATHODE) POSITION 2

THIS END TO POWER
SUPPLY