beautypg.com

Warranty, Product returns – Code 3 PSE460H Remote Strobe Power Supply User Manual

Page 12

background image

Public Safety Equipment, Inc.

10986 N. Warson Road

St. Louis, Missouri 63114-2029—USA

www.code3pse.com

Problems or Questions? Call our Technical Assistance HOTLINE - (314) 996-2800

WARRANTY

This product was tested and found to be operational at the time of manufacture. Provided this

product is installed and operated in accordance with the manufacturer's recommendations, Public Safety
Equipment guarantees the 460H for a period of 1 year from the date of purchase or delivery, whichever is
later. Units demonstrated to be defective within the warranty period will be repaired or replaced at the
factory service center at no cost.

Use of a lamp or other electrical load of a wattage higher than installed or recommended by the

factory, or use of inappropriate or inadequate wiring or circuit protection causes this warranty to become
void. Failure or destruction of the product resulting from abuse or unusual use and/or accidents is not
covered by this warranty. Use of non-PSE components and assemblies may cause damage to the
system and/or personal injury, and voids all warranties on PSE systems and components.

PSE shall in no way be liable for other damages including consequential, indirect or special dam-

ages whether loss is due to negligence or breach of warranty.

PSE MAKES NO OTHER EXPRESS OR IMPLIED WARRANTY INCLUDING, WITHOUT LIMITA-

TION, WARRANTIES OF FITNESS OR MERCHANTABILITY, WITH RESPECT TO THIS PRODUCT.

Revision 2, 01/2006 - Instruction Book Part No. T03595

©2004-6 Public Safety Equipment, Inc. Printed in USA

Cycle Flash and PSE Amber are trademarks of Public Safety Equipment, Inc.
Amp is a trademark of Tyco Electronics Corp.

PRODUCT RETURNS

In order to provide you with faster service, if you are going to return a product for repair or replace-

ment*, please contact our factory to obtain a Return Goods Authorization Number (RGA number) before
you ship the product to Public Safety Equipment. Write the RGA number clearly on the package near
the mailing label. Be sure you use sufficient packing materials to avoid damage to the product being
returned while in transit.

*Public Safety Equipment, Inc. reserves the right to repair or replace product at its discretion and assumes no

responsibility or liability for expenses incurred for the removal and/or reinstallation of products requiring service and/or repair.