Code 3 PSE235 Remote Strobe Power Supply - Manual (Page 6)

3. With the AMP 3 pin connectors terminated properly , plug each cable into the appropriate 3 position socket
on the PSE235 strobe power supply, see Figure 3, page 5.
POWER-INPUT WIRE HARNESS ASSEMBLY
The Power-input/Control harness is to be connected to the 4-position socket connector on the PSE235 strobe
power supply. See Figure 3, page 5. The Power-input/Control harness is to be connected to customer
supplied wiring and a customer supplied switch to complete the installation.
The Power/Control Harness consists of (See Figure 4):
Red - Power input wire. This wire is to be connected to the power source of +12/24VDC. This is a
High-Current input. When connected the power supply will be powered-up in Double Flash
mode.
NOTE: The red power wire must be connected to the power source, directly or through an
appropriately rated switch, for the power supply to operate.
Black - Ground/Earth wire. This wire is to connected to a solid ground or the Negative terminal of the
battery.
Orange - Quad Flash mode wire. This wire is to be connected to +12/24VDC for the Quad Flash mode.
This is a low current input. When connected to +12/24VDC it will override the Double Flash mode.
Green - Hi/Lo power control wire. This wire when connected to +12/24VDC will place the power supply
into low power mode. If not connected the power supply will be in high power mode. It is
recommeded that this wire be removed from the harness if Lo power mode will not be used.
This is a low current input.
6
FIGURE 4
Flash Control Harness Assembly
PSE PN 3569
Black - Ground/Earth
Red - Power input
Orange - Quad Flash mode
Green - Hi/Lo power control
This end to power supply