Code 3 PSE235 Remote Strobe Power Supply - Manual (Page 4)

Installation and Mounting
MOUNTING THE MODEL PSE235 REMOTE STROBE POWER SUPPLY
To obtain maximum performance and durability the Model PSE235 should be mounted as follows:
1. Mount the unit with the strobe light outlets located in such a way that they are easily accessible.
2. Mount the unit with the four supplied #8 sheet metal screws. If possible, a metal surface should be chosen
for best heat dissipation. The mounting hole pattern dimensions are shown in Figure 1. The power supply
can be used as a template, if desired, to mark the drill locations. Predrill this surface with a 9/64 drill and
secure the unit.
4
WARNING!
!
The Model PSE235 Strobe Power Supply is NOT waterproof and should be located in an area
protected from the weather and water.
WARNING!
!
High voltages and/or temperatures are present inside the unit. Disconnect from power and
wait 5 minutes prior to servicing or troubleshooting. Use hand and eye protection when
changing halogen lamps or flashtubes.
FIGURE 1
WIRING
STROBE LIGHT HEAD CABLE CONNECTIONS
1. Install the remote strobe light heads in the desired locations and route the three wire cable from the remote
heads to the PSE235 power supply. Leave enough cable at the power supply so that the cables are not
strained when connected to the power supply. Follow all installation instructions supplied with the remote
strobe light heads to determine how the cables connect to the strobe heads. PSE offers a variety of strobe
light head options that can be powered by the PSE235.
7.00
2.00
.141