Code 3 NP 130 NightProbe - Manual (Page 7)

7
Tr o u b l e s h o o t i n g
Product does not activate a. No power to unit a. Check wiring
b. Fuse blown b. Replace fuse
c. Ignition not on c. Turn on ignition
d. Controller cable not connected d. Check cable connection
f. Damaged or shorted cabling f. Check cables for damage
Unit operates but no light a. Lamp burned out a. Replace lamp
b. Switch on controller not engaged b. Push button on controller
Light operates but unit not moving
a. Motor damage a. Return to Code 3 Inc.
b. Unit hitting obstacle b. Remove obstacle
P R O B L E M PROBABLE CAUSE R E M E D Y
S p e c i f i c a t i o n s :
Mechanical Dimensions: Width: 7.25"
Depth: 12"
H e i g h t :
lamp down 4"
lamp raised 12"
R o t a t i o n : 360 degrees
E l e c t r i c a l :
Operating Voltage: 10 - 15 VDC
Current draw:
Lamp 'on' approx. 10A @ 12.8 VDC
Lamp 'off' approx. 35mA @ 12.8 VDC
Lamp Rating 100 Watts @ 12.8 VDC
Finishing:
To prepare the surface of the Night Probe for finishing wipe it with alcohol
or clean ultrasonically.
Mask off all bearing surfaces before finishing.
Water base and solvent paints based on aliphatic hydrocarbons (mineral
spirits, heptane, hexane and alcohols) have good compatibility with the
Night Probe material.
Chlorinated and aromatic solvents, as well as ketones should generally be
a v o i d e d .
C u r i n g :
Paints used on the Night Probe material can be cured using either air-dry
or bake techniques. Circulating warm air ovens are the best suited and
most economical method of drying.
Curing conditions will vary depending on the coating and part design. Bake
temperatures of 250 degrees F (121degrees C) are acceptable with Night
Probe material.