Code 3 NP 130 NightProbe - Manual (Page 3)

3
Connect the red and black wires from the NightProbe spotlight as shown in Figure 2. Protect the circuit
with a 15 Amp fuse and use 14 awg (minimum) wire.
Connect the white wire from the unit to an ignition switched circuit protected by a fuse (3 Amp Max.). Use
a 22 awg. (minimum) wire.
Failure to connect the wiring as stated above could cause damage to the unit.
The NightProbe spotlight must never have its lamp on when its head is in the closed position (as
shown in Figure 2). The extreme heat of the 100W lamp will damage the unit base.
Wiring Instructions
!
Route wiring using grommets and sealant when passing through compartment walls. High
ambient temperatures (e.g. under-hood) will significantly reduce the current carrying capacity of
wires, fuses, and circuit breakers. Use "SXL" type wire in engine compartment. Minimize the
number of splices to reduce voltage drop. All wiring should conform to the minimum wire size
and other recommendations of the manufacturer and be protected from moving parts and hot
surfaces. Looms, grommets, cable ties, and similar installation hardware should be used to
anchor and protect all wiring. Particular attention should be paid to the location and method of
making electrical connections and splices to protect these points from corrosion and loss of
conductivity. Ground terminations should only be made to substantial chassis components,
preferably directly to the vehicle battery. The user should install a fuse sized to approximately
125% of the maximum amp capacity in the supply line and each switched circuit to protect
against short circuits.
W A R N I N G !
I M P O R TA N T:
!
Any electronic device may create or be affected by electromagnetic interference. After installation
of any electronic device, operate all equipment simultaneously to insure that operation is free of
interference.
W A R N I N G !
Figure 2
Figure 3
N P 1 3 0
Control Cable
Pendant Cable
(Wired version only)
PWM Jumper
Connector
Orientation
PWM OFF PWM ON
IMPORTANT:
Make sure connector is
in the correct orientation
RF Remote
Training Switch