Code 3 LED X Side-By-Side - Manual (Page 4)

4
Programming:
Programming the desired flash pattern (or operation mode ) is done with the white control
wire. You can scroll through the twenty-one available flash patterns, by momentarily ground-
ing the white control wire until you arrive at the desired operation mode. Momentary ground-
ing of the white wire can be accomplished either by momentarily touching the wire to GND,
or through a momentary push-button switch.
The unit will come on in the default Cycle-flash mode at the time of first power-up, until the
desired flash pattern is programmed. The default flash pattern can then be changed by
programming the desired pattern into the unit, the unit will continue to operate in the same
mode every time the unit is turned off and turned back on. The default flash pattern can be
changed at will for any number of times.
The unit can be reset back to the default flash pattern ( cycle-flash ) by grounding the control
wire for about 8-10 seconds and then releasing it. This can be done while operating in any
of the flash modes.
Flash Modes:
Alternating Heads Simultaneous Heads Steady with Flashing
Cycle Flash Quad Flash
Fast Double Flash w/Steady
Single Flash Triple Flash Quad Flash w/Steady
Double Flash Double Flash
Triple Flash Single Flash
Quad Flash Pursuit Flash
Five Flash
Fast Single Flash
Fast Double Flash
Fast Triple Flash
Fast Quad Flash
Quad Pop Flash
Triple Pop Flash
Double Pop Flash
Wig-Wag Flash Alt.
Note: All modes flash at a rate of 70 fpm minimum. Fast modes flash at a rate of 100 fpm
minimum.
Options & Specifications
(Currents are calculated at 12.8 volts)
MODEL H L D WEIGHT OPERATING CURRENT FLASH
VOLTAGE DRAW RATE
2 Head L.E.D. 1.75" 1.60" 8.75" 2.75" 1.3 lbs 10-16Vdc .6A avg 70 fpm
warning system min