Code 3 LED X Side-By-Side - Manual (Page 3)

3
Figure 1
WARNING!
!
If the product is to be used inside the vehicle, it may cause severe personal injury if not properly
mounted and secured. Objects used in vehicle may become airborne during a collision or other
sudden changes in vehicle speed or direction, such as braking, acceleration or turns.
Wiring:
The side by side LED-EX modules are equipped with 3 - 8" long wires.
Connect wires as follows:
1. Red wire: Power wire, connect to +12V voltage line.
2. Black wire: GND wire, connect to ground terminal.
3. White wire: Control wire, may be left unconnected. It can also be connected to
GND through a momentary push-button switch, and be used for programming the
operation mode.
Note: The white wire should NOT be connected to a positive voltage under any
circumstances.
Installation:
Side by Side Exterior LED Module:
This unit can be mounted to metal surfaces using two #8 x 1" pan head sheet metal screws
(included). It is recommended that the wire access hole is drilled so that it is centered across
the width and the length of the module (Refer to Fig.1). An optional mounting rubber gasket,
included with the unit, may be used to prevent oxidization and galvanization of the mounting
surface due to metal-on-metal contact.