Code 3 LED X Exterior Lights - Manual (Page 9)

LED module housings may become hot with
extended use. Allow modules to cool completely
before attempting to remove.
WARNING! !
Maintenance:
The Exterior LED Modules are completely sealed units designed to be trouble and
maintenance free. Refer to the guide below for help with troubleshooting. Should the unit be
diagnosed as malfunctioning, remove unit and replace with a new module.
TROUBLESHOOTING
Problem Probable Cause Remedy
Lighthead does not
activate a. No Power to unit
b. Power input wire reversed
c. Damaged or shorted
cabling
d. Defective Lighthead
e. Control wire permanently
grounded or shorted to
GND a. Check wiring for loose
connection
b. Reverse Power wires
c. Check cables for
damage
d. Replace lighthead module
e. Avoid permanent
grounding of control wire
Lighthead is constantly
ON
a. Control wire permanently
grounded or shorted to
GND a. Avoid permanent
grounding of control
wire
Note: It is possible to program the two heads on the dual module individually as
shown on page 7. This should be done when a different flash pattern is
desired for each head. The two heads can also be programmed
simultaneously into the same flash pattern by tying the two white control
wires together then programming as shown on page 7.
9