Code 3 LED Perimeter Lights - Manual (Page 4)

4
FIGURE 1
Gasket Dimensions
(For Layout Purposes Only. Do Not Scale.)
13. Verify the “TOP” lens marking is on the top and install the lens using four screws. Two screw options are
supplied: four #10 x ¾” screws or four #6 x 1-½” screws. The #10 screws attach the lens to the LED base
unit. The optional longer #6 screws go through the LED base unit and tap into the vehicle body. If the longer
#6 screws are used then first drill an appropriate pilot hole into the vehicle body.
12. Mount the LED base unit and gasket (and bezel if used) using four #10 x ¾” screws. Optionally the unit
may be mounted with very high bond tape (customer supplied). If tape is used it should be attached to the
base unit and the vehicle. Do not use tape to secure the gasket to either the LED base unit or the vehicle
chassis. Follow the tape manufacturer’s instructions to ensure proper adhesion.
MODEL WIDTH HEIGHT
45 7.84 3.67
65 7.00 4.6
85 9.77 7.78
45BZ 9.18 5
65BZ 8.00 5.6
85BZ 11.1 9.11