Code 3 LED Hide-A-Blast - Manual (Page 6)

FLASH PATTERN SELECTION
FLASH MODE
Any one of the 30 Flash Patterns may be selected by using the blue wire to scroll through the pat-
terns. Touch the blue wire to ground for about 1 second and then remove it. The flash pattern will
switch to the next pattern. When the yellow wires (SYNC) from each light are connected, lights
with Phase 1 patterns selected will flash in an alternating sequence with lights that have a Phase 2
pattern selected. The following patterns are available.
description Phase
1. 75FPM Single Flash sim. Phase 1 Sim.
2. 75FPM Single Flash sim. Phase 2 Sim.
3. 75FPM Single Flash Alt. Alt.
4. 150FPM Single Flash All sim. Phase 1 Sim.
5. 150FPM Single Flash All sim. Phase 2 Sim.
6. 150FPM Single Flash Alt. Alt.
7. 75FPM Double Flash sim. Phase 1 Sim.
8. 75FPM Double Flash sim. Phase 2 Sim.
9. 75FPM Double Flash Alt. Alt.
10. 150FPM Double Flash sim. Phase 1 Sim.
11. 150FPM Double Flash sim. Phase 2 Sim.
12. 150FPM Double Flash Alt. Alt.
13. 75FPM Quad Flash sim. Phase 1 ( factory default) Sim.
14. 75FPM Quad Flash sim. Phase 2 Sim.
15. 75FPM Quad Flash Alt. Alt.
16. 150FPM Quad Flash sim. Phase 1 Sim.
17. 150FPM Quad Flash sim. Phase 2 Sim.
18. 150FPM Quad Flash Alt. Alt.
19. 75FPM TripleAlter sim. Phase 1 Sim.
20. 75FPM TripleAlter sim. Phase 2 Sim.
21. 75FPM TripleAlter Alt. Alt.
22. 150FPM TripleAlter sim. Phase 1 Sim.
23. 150FPM TripleAlter sim. Phase 2 Sim.
24. 150FPM TripleAlter Alt. Alt.
25. Steady Burn Sim.
26, Variflash sim. Sim.
27. 2 Double Flash, 2 TripleAlter sim. Sim.
28. 4 Single Flash, 2 Quad sim. Sim.
29. Sequential Back and Forth Sim.
30. OFF
-
6
1. Connect the Power/Control wire harness assembly to a switch. To select one of the 30 different flash func-
tions, turn the light on and touch the bare end of the blue wire to ground for about one second. You can also
scroll backward through the flash pattern table (see the PATTERN SELECTION TIMING section for complete
details. Repeat this process until you reach the desired flash pattern. After you have selected the desired
flash pattern, you should cover the bare end of the blue wire with heat shrinkable tubing to prevent an ac-